9 problemas e soluções comuns para puncionadeiras

Tempo estimado de leitura: 2 minutos

When we use a prensa de soco to make products, there are often some failures. So, what are the common faults when punching presses? How should they be handled? Let’s take a look at the following introductions.

Here are some common faults and solutions for punching presses:

1. The emergency stop button of the punching machine is not reset or has poor contact.

Solution: Rotate the button in the direction of the arrow to restore the original position or replace the button.

2. After the emergency stop, the prensa de perfuração slide block is not returned to the top dead center for a single time.

Solution: Use the inching specification to return the slider to the top dead center.

3. The indicator light for insufficient air pressure on the punch press does not light up.

Solution: Detect the part where the air pressure is insufficient and adjust it.

4. The micro switch of the overload protection device is not adjusted properly.

Solution: readjust and test.

5. Power supply and circuit failure.

Solution: Check the power supply and related circuits.

6. Increased clutch cylinder stroke on the punching press.

Solution: Use tools to adjust and adjust the stroke to the normal range.

7. The clutch piston is stuck or leaking on the punch press.

Solution: Use tools to repair or replace the clutch.

8. The clutch generates heat due to the high number of single strokes when the prensa de soco works.

Solution: Reduce the number of single operations.

9. The clutch solenoid valve is leaking or the coil is short-circuited when the máquina de perfuração is operated.

Solution: Repair or directly replace with new parts.

Por favor clique no link https://www.harsle.com/Punching-Machine.html para obter mais informações sobre a máquina de perfuração!